Reviews of ECO Heater T400U Wall Mounted Ceramic Convection Heater

Customer Ratings:
List Price: $129.95
Sale Price: $110.46
Today's Bonus: 15% Off

Great concept, however the biggest flaw is the thermostat. The unit itself comes packaged well and is very easy to install. They even include a drill bit for the correct size holes needed for the wall anchors. I have this installed exactly as instructed in our baby's room. We wanted to keep the temperature in the room at exactly 74 degrees. The heater's thermostat is not accurate to even 2 degrees. Best bet is to get the non-digital thermostat version and buy the Lux wall plug thermostat.

Click Here For Most Helpful Customer Reviews >>

Very easy to install and does a very good job to turrn a normally cold room into one that is very comfortable. The only downside is the thermometer. It seems to do the job of getting hotter as the number goes up, but the actual use of it to serve as a thermostat for the room is not so great. I might consider an external thermostat for my next version instead of it being built in. Overall, a good heating solution for a small to medium sized room.

Best Deals for ECO Heater T400U Wall Mounted Ceramic Convection Heater

This is a very elegant heater for small spaces. It's a nice matt white finish out of the box, and the textured ceramic finish is paintable. I bought this to replace the TERRIBLE Envi 220V heater a customer had me install (malfunctioned, right out of the box; customer service wouldn't accept the return without the box, nor pay return shipping in any case). The finish appearance, installation process, and the fact that the thing worked, were all refreshing improvements over the Envi heater. I was able to convert my 220V hard-wired connection to a shallow-wiremold surface mount 120V duplex receptacle on a 15A GFCI circuit breaker. At only 400W, there's no need for 220V for this type of heater, anyway. Now, the customer gets an extra GFCI receptacle socket so they could shave and use a hair dryer at the same time, if they wanted!

The installation in wall-board or flat masonry walls was very straightforward using the supplied integrated-standoff-and-wall-anchor device.

Single-use anchor/standoffs could be a problem for some users / applications

Should you be mounting to a wood wall (maybe you shouldn't, due to heat or potential malfunction and fire?) or some other material that does not support an expanding plastic anchor fastening method, you may be out of luck. Also, measure three times before drilling for the anchors (masonry bit supplied) or installing them, since the unit ships with only the 4 you will need, and you won't find anything that will work as a substitute at the hardware store. Don't lose, use in the wrong location, or break these anchor/standoffs!

Thermostat defaults to 72 whenever power is cycled off and back on.

The integrated logic-controlled thermostat seems to work well, although it does not remember the user setting after cycling the power off; it defaults to 72 degrees Fahrenheit as the set temperature when turned back on. Setting memory would be nice in case you want to operate it through a wall-receptacle timer device. 72 is not too bad a default setting, but users may wish they had more options to set their own target for when the timer turns the unit on again after down time.

Not for use in bathrooms?

The instructions state that the unit is "not intended for use in bathrooms or other areas where users could be in contact with water while operating the unit". I presume the manufacturers don't trust your existing receptacle to be GFCI-protected (many older bathroom, laundry, kitchen and basement receptacles are standard type where they should be GFCI-protected due to the likelihood people may be solidly grounded to water pipes or wet masonry floors while contacting the receptacle device, it's cover, or a cord-connected appliance that has a dangerous ground-fault. I consider that when connected to a GFCI in a plumbed location like a bathroom, the T400 U unit should be safe to operate.

Find more about this installation and other electrical products and topics, at my site PhillyLicensedElectrician.com. Or just Google "Robert Monk [any electrical question]" for articles on most general electrical topics, from simple receptacle grounding and tripped breaker troubleshooting to solar photovoltaics, generators, electric vehicles and and fuel cell power supplies.

Honest reviews on ECO Heater T400U Wall Mounted Ceramic Convection Heater

We really like this one with the built in thermostat we have it in a bathroom in it helps out in the winter time to keep the bathroom extra warm. I would highly recommend this item and I would buy it again if I needed one.

Find helpful customer reviews and review ratings for ECO Heater T400U Wall Mounted Ceramic Convection Heater

bought it for a bathroom with out a lo of room

installed easy but does not throw off a lot of heat