List Price: $342.62
Sale Price: $215.00
Today's Bonus: 37% Off
I am very pleased with this heater. It has one or two quirks that I didn't expect (hence the 4.5 stars), but it puts out a terrific amount of heat, looks great and was a real bargain Amazon is the best.
What I didn't expect:
* It's much larger than I expected. My impression based on the pictures I could find was that it was much smaller, but be prepared for a sizeable heater;
* Contrary to the description, it doesn't have a digital temperature readout. I was a little annoyed at first, but then most temperature gauges don't work well anyway, and I heat the room to feel comfortable and not to a specific temperature, so this doesn't matter much to me now;
* The thermostat works differently than I expected. The unit puts out a constant amount of heat, regardless of the setting, but the higher thermostat settings make the unit run until the room is hotter before it shuts off, which works fine;
* I run my heater on a 40 lb. propane bottle. If you plan to run on a bottle, be prepared to buy a pressure regulator, hose and some fittings. Oddly, I couldn't find the right combination from Mr. Heater, but did buy the Red Dragon kit on Amazon, which works well. The only other fitting I needed was an adapter from 3/8" NPT to 3/8" flare, which was only $3 at the local hardware store;
* I read reviews elsewhere that the internal fan is quiet. I like the fact that it has the fan, but find it a bit noisy to my taste. Since I have a vaulted ceiling and ceiling fans, I will rarely use the internal fan. It seems to work fine without it and runs almost silently, which is very nice.
Overall, a real deal in my opinion that suits my needs almost perfectly.
August 2011 Update: A few more observations after using the heater for a while:
* we can smell the byproducts of combustion in the room when we use this heater. This is not surprising since the combustion gases are vented into the room. As a result, we use it sparingly (usually just to warm the room) since the smell can be unpleasant, and undoubtedly isn't good for your health if used extensively;
* burning propane relases a fair bit of water vapour into the room, so we get condensation on the windows. Again, this is not a surprise;
* this heater is certified by the Canadian Standards Association (CSA), which is one of the reasons I bought it. However, the CSA approval is only for use in the USA; these types of unvented heaters are not approved for use in Canada;
* I did some reading online about unvented heaters (sadly after I bought this unit). Anyone interested in buying unvented heaters would do well to read up about the pros and cons before buying.
Click Here For Most Helpful Customer Reviews >>
Ordered the heater back in May of 2012. A licensed plumber (certified in propane) installed the 16 feet of propane line. My jaw dropped when I got his bill: $400.05 -did he really need to include that nickel? The heater cost me $179.95 and I see that it is now going for $239.95. You might want to purchase it off season.I hooked up the heater to a 15 gallon propane tank and connected the line to the tank using a Mr. Heater 5-Feet Propane Hose/Regulator Assembly. It says right on the regulator, "LOW PRESSURE." ***BE SURE YOUR REGULATOR CAN DELIVER LOW PRESSURE (i.e., it may be a hose rated for high pressure that you can turn down, but you need to run low pressure into the heater or it can damage it. I didn't want to take that chance of any faulty guesswork, so I purchased the hose that had the words "LOW PRESSURE" stamped right on the regulator).
11/07/2012 -EDIT: I wish I had seen this before I bought the other hose hookup. I would have purchased it: Red Dragon SL-1C Low Pressure Propane Hook Up Kit With 10-Foot Hose. Just copy and paste it into the search bar and see what you think.
The instructions tell you to put the control knob on "Pilot" and then press it down (push on it straight down, toward the floor) and hold it for 30 seconds if this is the first time you're using it. Boy, were they ever wrong. First of all, it depends on how long your line is from the tank. My 16 foot run took about 3 minutes to get gas to the pilot light! So, be patient and don't do what I did -wasted some of my AA battery by clicking the igniter constantly for about 30 seconds before I realized what was happening. Just keep holding that big knob down in the Pilot position and then try the igniter every 15 seconds or so until it flames. Once that flame starts, they say to continue depressing the knob for another 30 seconds. Well, that's a bunch of bull crap. You can take your hand off after 6 seconds. Count 'em. The flame will not blow out the pilot once 6 seconds have ticked by.
Our house is 1,727 sq ft. We keep all three bedroom doors, the guest bathroom door and the laundry room door, closed. I'm guessing we're heating around 1,100 sq ft with the heater.
Here are some statistics you might find interesting...
A gallon of propane weighs approximately 4.2 lbs.
A gallon of propane has a burn rate of approximately 100,000 BTUs (British Thermal Units) per hour. This means that if you run your heater continuously (30,000 BTUs) you will be consuming propane at a rate of about 1/3 gallon per hour. At 33,000 BTUs, your heater would be right at the1 gallon per hour approximation. I am guessing that my 15 gallon propane tank could therefore run for about 50 hours (because I'm only burning 30K and not 33K). The shorter the time you have your heater on, the longer you'll go between refills of your propane tank. (What's HUD spelled backwards?)
Since I don't want to do the math to calculate how long I can go (in theory) between refills by running my heater for 6 minutes on after each 50 minutes off (see my experiment below), 14 times per day, I went ahead and wrote the date of the last fill on the tank itself. When it becomes empty, I will have my answer and I'll let you know. I started with an empty tank and it took on 14.4 gallons of propane when I filled it at the local station. By the way -I paid $2.99 per gallon! It is much cheaper at other locations, but I was too excited to wait.
Here are some results from a runtime experiment I've conducted:
Cycle #1:
Outdoor temperature: 55.6 F
Indoor temperature: 68.4 F
Time heater not burning: 56 min 46 sec
Time heater burning: 5 minutes 50 seconds
Cycle #2:
Outdoor temperature: 56.8 F
Indoor temperature: 68.5 F
Time heater not burning: 44 min 3 sec
Time heater burning: 5 min 54 sec
Cycle #3:
Outdoor temperature: 56.8 F
Indoor temperature: 68.5 F
Time heater not burning: 51 min 39 sec
Time heater burning: 5 min 32 sec
On the large heat control knob, there are small raised dots. There is a dot right at the "1" and then four more dots is where the "2" is. To achieve these runtime intervals (i.e., on/off times), I have set the dial to one dot past the "1" and this is where we achieve our 68 degrees (with temps in the 50s outdoors).
Something you should also know, and I had to find this out from experience. I thought that the low setting would set the flame lower and on the high setting, the flames would be larger. Not so. The dial is merely a thermostat. The flames are pretty much full whether the heater is on LOW or on HIGH. I did notice a little more flame at the very top end of the dial, but it's not much. To control the temperature in the house, therefore, all you need to do is select a spot on the dial and leave it there.
We keep our house at 68 degrees and dress warmer if we get a little chilly. But I am here to tell you, you'll burn a lot more propane if you keep your house just 2 degrees warmer and to us, it's just not worth it. We "wear" our 2 degrees and it doesn't cost us a penny more.
Here's something else -the pilot runs while the flame is off. BUT -when you are not going to be running the heater, just turn the whole thing off, including the fan.
The fan is rather wimpy, but adequate. I think it moves more air than we might think, but if you want more "wind," you might want to augment it with a small electric fan.
CARBON MONOXIDE CAN KILL YOU! -Having researched many opinions about vent free heaters running inside a home, I decided to go out and purchase a CO (carbon monoxide) detector with alarm. I have a model that includes a digital display of actual levels of Carbon Monoxide and it displays the reading in parts per million. The very first sign of CO poisoning is a frontal headache. Go read all you care to about CO poisoning and what symptoms are brought about by what levels of toxicity (you never want it above 70ppm and you definitely need to leave the house if it ever gets up to 100ppm, but my device detects zero Carbon Monoxide. I have placed the device atop a set of shelves about 30 inches, nearly directly above, the heater. That said, we still have plenty of ventilation in our manufactured home (bathroom fans pull air into the enclosure through vents in our window design) and the heater does come with a low oxygen shut-down safety feature. Which I don't trust. Which is why I bought the CO detector/alarm unit.
Obviously, it is still a warm Autumn with mild outdoor temperatures. But that's all gonna change soon. We bought this heater in preparation for the power outages we'll face when the big Pacific Northwest storms start pounding us.
I am giving the Mr Heater Model #VF30KBLUELP 30,000 BTU Vent Free Propane Heater 5 stars. Wimpy fan or not, this is a kick-butt alternative to any dependence on electric furnaces when the power goes out. And I think it can also hold its own as a primary heat source in any area with adequate ventilation (along with a CO detection device, just to be on the safe side).
Hope this review helped.
Best Deals for Mr. Heater 30,000 BTU Propane Blue Flame Vent-Free Heater
I have used several different types of this kind of stove in different locations. Currently have an all electric house with a pellet stove. Found a really nice like new 50 gallon upright propane tank at a yard sale that I'm using right now.This is not a good do it yourself project for a home owner. These things require a real installation from someone trained and qualified. Once I got the tank, it needed a regulator, a POL, two pieces of flex (one outdoor, one indoor) a ball shut off valve, some schedule 80 black iron pipe to go through the wall with a lot of other pipe parts and a sediment trap.
THEN once everything is set up, it REQUIRES a real leak test and a gas check before it's put into service.
Once all that was installed correctly and completely tested out? It worked great. Probably took over half an hour to get gas to the pilot light though. Which is normal, air gets in there and it has to be purged out while the thing is attempting to get lit up.
Settings on the control go from 1 5. Have not had it beyond the '1' mark yet. 3 bedroom, two bath house getting into the 20's at night, mid 30's during the day I used 10 gallons of propane the first week.
Can't hear it come on and off as it cycles through it's thermostat. Fan has an automatic setting so it doesn't have to run all the time, either.
Big plus with this one for me was that it comes with the legs and fan. Isn't as much fun to watch as my old vent free fireplace but it sure does get the job done for heating this house and is probably less than half what the stupid pellet stove was costing me. With NO hassle. And the propane company will come out and fill the tank the day after I call if it starts getting low.
Couple of the wood stove die hard neighbors are coming around to check this out. Can imagine it won't be too long before they have one of these, too!
It probably took a little over 2 1/2 hours to install.
The shipping on this was a real treat, too. Came right away in perfect shape. Sure don't have any complaints on this one!
Honest reviews on Mr. Heater 30,000 BTU Propane Blue Flame Vent-Free Heater
This heater works as well as I had hoped it would and I couldn't be happier with the purchase. The "auto" function for the blower fan, for example, causes a delay in the fan operation until enough heat is built up from the flame before it comes on. When the target temperature is reached, the flame goes off and the fan continues to run until it is no longer blowing warm air, then it stops blowing. In other words, this little portable heater work exactly like the furnace in your house is designed to work. It exceeds my expectations.Find helpful customer reviews and review ratings for Mr. Heater 30,000 BTU Propane Blue Flame Vent-Free Heater
Ok, I took a little time before reviewing this heater because I wanted to use it for a few days. Here is what I found. Some have said it is large. Yes, its a bit large but it puts out 30,000 BTU's and heats my cabin of 1,000 sq ft. It's not a portable like Mr Heaters Big Buddy's which I also have. There are no handles on it to carry it around. For me at least it is a permanent heater. You can hang it on the wall or attach the legs for floor use.Setting it up was not difficult but be aware you will need some pipes and connections as it only comes with one elbow for floor use. Some parts I got from Amazon and had my local hose guy put it all together. I did the rest.
Now comes the use of it. At first I had a few problems with the thermostat. It would come on and stay on which made my cabin way too hot. After texting with Bill Sisley at Mr Heater, a great tech by the way, He helped figure out my problem. Notice I said my problem not the heaters. The problem was a draft.
Now the thermostat works perfectly and so does the blower fan. The heater works like a furnace in a large house
All in all it's a great heater and I would recommend it. Just know, you will need to purchase some parts.
One last thing, The heater including the fan is very quiet.
No comments:
Post a Comment