List Price: $498.84
Sale Price: $348.99
Today's Bonus: 30% Off
i really like this unit, and it works really well.although i think the pilot flame could be smaller even when adjusted all the way down. just seems like a big waste of fuel. but still a great unit...
Click Here For Most Helpful Customer Reviews >>
Just installed in a 28 x 24 garage with an 8' ceiling (the ceiling is not completely insulated yet). It's a cold windy day (0 degrees wind chill), and this heater is keeping the garage warm enough to work in a flannel shirt. Without the ceiling being finished, much of the heat is obviously escaping right out the roof vents. I do believe that once the ceiling is completed, it will do a fine job in this garage.Shipped quickly from Amazon with no damage; instructions easy to follow; installation was simple. Called Mr. Heater's Customer Service line with a simple question, and after punching a few buttons to get to the correct department, I actually spoke to a real person who also spoke English. Thermostat wiring could have been a bit longer.
Two points to consider when installing:
One, although overall very light, the heater is quite a bit heavier on one end due to the control valve, making it necessary to put a slight bend in the hanger to make it hang level. The factory could have positioned the mounting point slightly to the left to counter balance the heater, but this is minor and easily corrected.
And two, be patient about letting air bleed from the gas line and getting gas through the control valve when you first light the pilot. My supply line is less than 40' from the tank to the heater, but it took several minutes of holding the gas valve in at the 'Pilot' position to get gas to flow.
I'd recommend one of these to anyone with similar heating needs.
Best Deals for Mr. Heater MH25LP 22,000-BTU Propane Radiant Heater
Great little heater, We have an insultated garage and at 30 F outside this week I was comfortable in just a sweatshirt and jeans.it does take a bit to warm things up but it just enough for the tinkering I do.
No comments:
Post a Comment